Doors, Panels and Pilasters shall be constructed of Solid Phenolic Core, comprised of melamine-impregnated decorative surface papers superimposed over a varying number of melamine-impregnated kraft paper sheets to achieve the desired thickness of each component. All sheets are fused together under high temperature and pressure to form a single solid sheet. Decorative surface papers are applied and bonded to meet and exceed NEMA standards. . All sheets have a flame spread of 80, smoke index of 200 and comply with ICC/ANSI A117.1.

Doors are 3/4” thick with decorative surface face sheets and black (core) edges.

Panels are 1/2” thick with decorative surface face sheets and black (core) edges.

Pilasters (Type H/B –Headrail Braced) are 3/4” thick with decorative surface face sheets and black (core) edges. A polished 3” high stainless steel shoe shall be supplied to conceal floor anchoring. Pilaster tops are securely braced together with a continuous anti-grip headrail of extruded aluminum alloy, polished and clear anodized.

Doors are 1” thick with all external edges and faces covered with decorative plastic laminate. All edge surfaces shall be applied prior to the overlapping face surfaces to seal edge and prevent laminate from being pried loose. Doors are pre-notched and recessed to accommodate concealed controlled gravity type hinges.

Panels are 7/8” thick with all external edges and faces covered with decorative plastic laminate. All edge surfaces shall be applied prior to the overlapping face surfaces to seal edge and prevent laminate from being pried loose.

Pilasters (Type H/B –Headrail Braced) are 1-1/4” thick with external edges and faces covered with decorative plastic laminate. All edge surfaces shall be applied prior to the overlapping face surfaces to seal edge and prevent laminate from being pried loose. Pilasters shall have adjustable floor anchor system including an integral jack-leveling device. A 3” high stainless steel shoe of one-piece construction, matching pilaster profile, shall be supplied to conceal floor anchoring. Tamper proof shoe assembly held in place by concealed floor anchor clips –exposed screws are not acceptable. Pilaster tops are securely braced together with a continuous anti-grip headrail of extruded aluminum alloy, polished and clear anodized.

Panels are 1” thick, constructed with two 22-gauge sheets of stretcher leveled, commercial quality electro-galvanized steel that are formed and then laminated under pressure to a sound deadening double-faced honeycomb core. Face plates are welded together at intervals of 18” on center around entire perimeter to insure a rigid one-piece unit. All edges are then interlocked with a continuous roll-formed edge molding. All mitered corners are welded and ground smooth. Corner clips will not be acceptable.

Type H/B –Headrail Braced Pilasters are 1-1/4” thick, constructed with two 20-gauge sheets of commercial quality electro-galvanized steel that are formed and then laminated under pressure to a sound deadening double-faced honeycomb core. Face plates are welded together at intervals of 18” on center around entire perimeter to insure a rigid one-piece unit. Edges are then interlocked with a continuous roll-formed edge molding. An inverted heavy gauge channel shall be welded into top of the pilaster for additional reinforcing. Pilasters shall have adjustable floor anchor system including an integral jack-leveling device. A polished 3” high stainless steel shoe of one-piece construction shall be supplied to conceal floor anchoring. Tamper proof shoe assembly held in place by means of concealed floor anchor clips –exposed screws are not acceptable. Pilaster tops are securely braced together with a continuous anti-grip headrail of extruded aluminum alloy, polished and clear anodized.